Correlated Number of Blows
The correlated number of blows N60 is calculated according to this equation:
![]()
The correlated number of blows N1,60 is calculated according to this equation:
![]()
where: | Er | - | Energetic ratio of the testing device |
N | - | number of blows measured during SPT test | |
CN | - | correlation for vertical stress | |
λ | - | user’s correlation |
The energetic ratio of testing device Er represents the ratio of real energy Emeas and the calculated energy Etheor of the ram. It is not necessary to use a correlation for a standard SPT device (Mohr), because the efficiency of the machine is 60 % and correlation is performed to this value (the values measured during SPT test are used).
Correlation CN for vertical stress σ'V - represents the influence of weight of overburden in sands. The values of the correction factor CN greater than 1.5 should not be used (according to EN ISO 22476-3 recommendations).
Table of built-in types of correlations
Type | Type of consolidation | Relative compactness lp [%] | Correlation factor CN |
Type 1 - EN ISO 22476-3 (Tab. A2) | Normally consolidated | 40 - 60 |
|
Type 2 - EN ISO 22476-3 (Tab. A2) | 60 - 80 |
| |
Type 3 - EN ISO 22476-3 (Tab. A2) | Over-consolidated | - |
|
Type 4 - EN ISO 22476-3 | Normally consolidated sands | - |
|
Type 5 - FHWA (1998), Peck (1974) | - | - |
|
where: | σ'V | - | Effective vertical stress |
User’s correlationλ [-] - represents the loss of energy due to the length of the system of rods, the impact of borehole diameter, or the influence of the sampling device.
The user correlation coefficient can be entered directly or calculated. If it is to be calculated, proceed as follows:
![]()
Table of corrections to SPT
Factor | Equipment Variable | Term | Correction |
Borehole diameter | 65 mm to 115 mm 150 mm 200 mm | CB | 1.0 1.05 1.15 |
Rod length | 3 m to 4 m 4 m to 6 m 6 m to 10 m 10 m to 30 m > 30 m | CR | 0.75 0.85 0.95 1.0 <1.0 |
Sampling method | Standard sampler Sampler without liners | CS | 1.0 1.1 to 1.3 |
Literature:
Robertson, P. & Wride, C.E.. (1997). Cyclic liquefaction and its evaluation based on SPT and CPT. Proc. NCEER Work-shop on Evaluation of Liquefaction Resistance of Soils. Report NCEER-97-0022, National Center for Earthquake Engineering Research, SUNY Buffalo, NY.
