SPT (Standard Penetration Test)
The result of Standard penetration test (SPT) is number of blows N (penetration resistance), needed to penetrate a sampling device to the soil or rock by a so called Interval of penetration depth 0,3 m (1 ft).
The number of blows N measured during the SPT test is correlated for the reason of various testing devices and for influence of weight of overburden in sands. Corrected (correlated) value N60 is used in calculations.
Correlated number of blows N60 is calculated according this equation:
Energetic ratio of testing device
number of blows measured during SPT test
correlation for vertical stress
Energetic ratio of testing device Er represents the ratio of real energy Emeas and the calculated energy Etheor of the ram. It is not a necessary to use a correlation for a standard SPT device (Mohr), because efficiency of its machine is 60 % and correlation is performed to this value (the values measured during SPT test are used).
Correlation CN for vertical stress σ'V - represents the influence of weight of overburden in sands. The values of the correction factor CN greater than 1.5 should not be used (according to EN ISO 22476-3 recommendations).
Table of built in types of correlations
Type of consolidation
Relative compactness lp [%]
Correlation factor CN
Type 1 - EN ISO 22476-3 (Tab. A2)
40 - 60
Type 2 - EN ISO 22476-3 (Tab. A2)
60 - 80
Type 3 - EN ISO 22476-3 (Tab. A2)
Type 4 - EN ISO 22476-3
Normally consolidated sands
Type 5 - FHWA (1998), Peck (1974)
Effective vertical stress
User’s correlation λ [-] - represents the loss of energy due to the length of the system of rods, the impact of borehole diameter, or the influence of the sampling device.
The result of SPT is its process plotted as a graph. The evaluation of standard penetration tests are used as input parameters for the analyses in the "" and " " programs and for stratigraphic modelling in the " " program.
Standard penetration tests can beinto the program as .txt data.
The name of the test and the depth of the first point of the SPT is entered in the "New field test" dialog window. In the "Stratigraphy" program, input of coordinations x, y, z is required.
The number of blows is entered in the table.
Dialog window "New field test"
EN ISO 22476-3: Geotechnical investigation and testing - Field testing. Part 3: Standard penetration test, 2005.
Roy E. Hunt: Geotechnical Engineering Investigation Handbook, Second Edition (CRC Press, 2005)